EPDM Rubber U Channel Profile Trim Car Vehicle Window Door Edge Weatherstrip
|Solid rubber extrusion
|WL Plastic and Rubber Manufacturer
Color:black, gray, yellow, red or as customer's required
Hardness: According to your requirement
The Property of rubber U Channel Profile
A: High flexible and plasticity, anti-aging, ozone and chemistry resistant, wearing-resistant.
B: Using range of temperature (minus 70 degree to 280 degree)
C: Without steel or wire in the core, also without glue.
No messy glue, sealant or permanent fixtures needed
D:It is easy and fast to install.
Just press on for a snug super tight grip, the flexible trim is metal lined
and has inner lips to provide a secure fitment
E:Good looking (decorative), good sealing capacity and effective edge protection
Imported rubber raw material,Gloss Appearance , long service life
Flexible enough to bend randomly
3.Multiple specifications and get optional randomly
The install place:
Seals the interior and exterior to prevent water, debris, and white-noise intrusion Fits edges:
See the picture show.
Just push on the rubber seal above the install place.
The rubber seal will be griping around the edge without adhesive or any other thing
Reduce the impact of the doors, extend the service life.
Seal the door gap, prevent muddy water coming.
Reduce wind noise, create a quiet environment.
Prevent the exposed air, make more comfortable riding.
Application Range of Rubber U Channel
The trims provide a permanent grip on the trim covers a huge variety of uses including: car,
camper, truck, boat, mini-van, van, trailer, bus, coach, lorry, motor home, caravan, truck, general
engineering and domestic use. Fitting cars such as - Mini, Ford, Hillman, Vauxhall
VW, Land Rover, Peugeot, Citreon, BMW, Mercedes, Porsche etc
Please measuring your car before buying the product
Please allow minor error due to manual measurement.
Due to the difference between different monitors
the picture may not reflect the actual color of the intem
The steps of installation
1. Clean up the installation location
2. Apply the adhesion promoter to the inside of the door
3. Rip the internal tape
4. Paste on the edge of the door
5. Pulling and pressing
6. Lose the extra parts